[PIE] LOOP CALIBRATOR PIECAL 334 PLUS

HOME >

자.관련상품보기

전압전류교정기

[PIE] LOOP CALIBRATOR PIECAL 334 PLUS

판매가: 견적문의

구매제한: 옵션당 최소 1개

구매혜택: 할인 : 적립 마일리지 :

배송비

0원 조건별배송

택배

/ 주문시결제(선결제)

방문 수령지 : 부산광역시 해운대구 우동1로20번가길 52-5(우동) 1층

상품코드: 2141

모델명: PIE 334 PLUS

브랜드: PIE

제조사: PIE

원산지: 미국

상품상세정보
배송안내
교환 및 반품안내
상품후기 (0)
상품문의 (0)

상품상세정보

[PIE] LOOP CALIBRATOR PIECAL 334 PLUS

4-20mA Loop Calibrator with Current Leakage Detector, Automatic Stepping & Ramping, and Built-in 250 Ohm HART Resistor

제품특징

The Piecal 334Plus 4-20mA Loop Calibrator with Current Leakage Detector, Automatic Stepping & Ramping, and Built-in 250 Ohm HART Resistor builds on the Pie 334 with advanced features unique to PIE calibrators. Easily find current leaks to ground, deteriorating & damp insulation or corroded terminals with patented loop diagnostic technology. Automated stepping (2, 3 or 5 steps) and ramping lets you set the 334 Plus at one instrument and check any other point in the loop.

Get better calibrations with a five digit display to 20.000 mA. You can read the display in dim conditions with the built-in backlight. Additional improvements over 334 from other manufacturers include better long term stability, accuracy, reliability & ruggedness plus improved battery life.

PLUS the PIE 334-Plus exceeds the performance of many higher cost calibrators to meet today's most demanding requirements while maintaining the familiar, time proven reliability and ease of use of similar calibrators. The PIECAL 334Plus is the new milliamp calibrator standard

제품사양

Specifications
Read mA
Ranges		0.000 to 52.000 mA Full Span
Resolution		-25.00 to 300.00% of 4-20 mA
Accuracy	Below 24.01mA	≤ ± 0.05 % of 24.00mA (± 0.01mA)
	Above 24.00mA	≤ ± 0.05 % of 52.00mA (± 0.02mA)
Voltage burden		≤ 2V at 50 mA
Overload/Current limit protection		54 mA nominal
Battery life		≥ 125 Hours nominal; ≥ 100 hrs with backlight on (334Plus)
Source/Power & Measure Two Wire Transmitters
Ranges		0.000 to 24.000 mA Full Span
Resolution		-25.00 to 125.00% of 4-20 mA
Accuracy	EZ Check(s) at4 & 20mA	≤ ±0.025% of Span at 4 mA & 20 mA (± 0.005mA)
	0.0 to 24.00 mA	≤ ± 0.05% of 24.00mA Span (± 0.01mA)
Noise		≤ ± ½ Least Significant Digit
Temperature effect		≤ ± 0.005 %/°C of FS
Loop compliance voltage		≥ 24 V DC @ 20.00mA
Loop drive capability		1200 Ω at 20 mA for 15 hours nominal; 950 Ω with Hart Resistor enabled
Battery life		Source and Power measure mode ≥ 30 hrs at 12 mA nominal; ≥ 25 hrs with backlight on
2-Wire Transmitter Simulation
Accuracy		Same as Source/Power & Measure
Voltage burden		≤ 2V at 20 mA
Overload/Current limit protection		24 mA nominal
Loop voltage limits		2 to 100 V DC (fuse-less protected from reverse polarity connections)
Battery life		≥ 125 hours nominal; ≥ 100 hrs with backlight on
Voltage Read
Range and Resolution		-99.99 to +99.99 V DC Full Span (FS)
Accuracy		≤ ± 0.05 % of FS
Temperature effect		≤ ± 100 ppm/°C of FS
Input resistance		≥ 2 MΩ
Battery life		≥ 125 hours nominal; ≥ 100 hrs with backlight on
General
Temperature Range	Operating	-20 to 60 °C (-5 to 140 °F)
	Storage	-30 to 60 °C (-22 to 140 °F)
	Relative Humidity Range	10 % ≤ RH ≤90 % (0 to 35 °C), Non-condensing
		10 % ≤ RH ≤ 70 % (35 to 60 °C), Non-condensing
Size		L=5.63 x W=3.00 x H=1.60 inches
Weight		12.1 ounces (including boot & batteries)
Batteries		Four “AA” Alkaline 1.5V (LR6)
Low Battery		Low battery indication with nominal 1 hour of operation left
Protection against misconnection		Over-voltage protection to 135 V rms (rated for 30 seconds) or 240 V rms (rated for 15 seconds)
Display		High contrast graphic liquid crystal display with 0.413” (10.5 mm) high digits