WEBSTER 웹스터경도계 MODEL B, B-75, BB-75

Products

The Webster Hardness Testers are a portable, fast, accurate hardness gauge that are made in three distinct models for testing Aluminum, Brass, Copper and Mild Steel. Webster Hardness Testers will quickly identify tempers and test a variety of shapes that other testers cannot check, such as extrusions, tubing and flat stock.

All testers operate in the same manner but differ only in penetrator design, type of load spring and hardness ranges. The principle of operation is simple. The work to be tested is placed between the anvil and the penetrator. Pressure is then applied to the handles until "bottom" is felt at which time the dial indicator is read.

​

Model B-75

The Model B- 75 Tester was developed to obtain more sensitive response to slight changes in the upper range of hardness covered by the Model B. This sensitivity is particularly useful in testing mild steel and the stronger aluminum alloys. For brass the B-75 covers the range from annealed to full-hard. This added sensitivity is accomplished by incorporating a penetrator of slightly different contour and a heavier load spring than used in the Model B. The 20 graduations on the Webster dial indicator covers the range between 20 and 100 on the Rockwell B Scale.

Model BB-75

The Model BB-75 Tester was developed to answer the need of certain industries for a method of rapidly testing the hardness of electro-deposited copper in the low hardness range. The B-75 penetrator is used to give sensitivity, and the Model B load spring is employed to give light pressures. This combination allows the user to test the soft range of many common materials. The graph below shows the range covered by the Model BB-75 tester on copper.

Applications and Features

Applications for Webster Hardness Testers are:

Identifies heat-treated from nonheat-treated parts.

Provides correlation between a bench mounted hardness tester and the production line.

Segregates materials in stock.

Differentiates between soft or work-hardened material.

Identifies parts made from improper or substandard alloys.

Checks for proper heat-treatment response.

Useful in conjunction with stationary laboratory hardness testers. Gives a rapid 100% check on parts which would consume many man hours with slower operating test equipment.

Can be used on assemblies that cannot be brought to the labs.

Webster Hardness Testers Feature:

One hand operation and portability.

Round 3/8 inch diameter anvil permits testing a great variety of shapes.

Simple operation permits readings independent of the operator's skill.

Test is made by simply applying pressure to the handles until "bottom" is felt.

Easy-to-read dial indicator with 20 graduations permits use of the tester as "go" and "no-go" gauge.

Standard hardness gauge tests materials up to 1/4 inch in thickness.

Increased capacities available up to 1 inch.